• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

snow

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
wow had the truck for 2 years and dont know theirs bearings in it.Tear it down to little pieces and familirize your self with it and if you can't get it back together sombody will give you a hundred bucks for it,lol
 
Your truck has many different bearings, there is a bearing or bushing where ever there is rotation, the main ones are the axle bearings 2 on each axle in the carriers, the 3 bearings on each diff, the clutch bell bearings, and the bearings on either end of the transmission. i think that is about it
 
yeah I found all the bearings I knew that there was bearings in there I've had my T Maxx 2.5 for 2 years and never had to grease a bearing I guess I'm just lucky
 
yeah I guess I'm just lucky

More than you know....

---------- Post added at 2:28 PM ---------- Previous post was at 2:24 PM ----------

mike tmaxx 33 said:
yeah, I found all the bearings. I knew that there was bearings in there. I've had my T Maxx 2.5 for 2 years and never had to grease a bearing, I guess I'm just lucky.

You're welcome.

---------- Post added at 2:36 PM ---------- Previous post was at 2:28 PM ----------

and what the hell r u guys talking about greaseing what everything seals I think there is no bearings I see

No, you didn't know that this truck has bearings. You said it you're self. ^^^^^
 
Last edited by a moderator:
It was an optical elusion,the servo is Still there,u just have to find it!
 
I thought I found it but than I realized it was only a dream and in that dream I had a tmax and my friend had a savage vxl and we raced and I won and I woke up happy
 
I'm probably not the right one to way in On this but here it goes. I've had my maxi for almost 3 years. I've had it running great for about 2 years ago. Last winter I waterproofed it for snow. I split the servos in half and put a small glob of waterproof grease on the horn where it pops thru the opening. Put the servos back together and covered in plasti-dip. Stripped my receiver and sprayed that with plasti-dip also. I insulated my engine to keep the heat up.

You can find you tube videos showing you how to do it all. I even took my truck in a small stream a lot this summer. After wet conditions I strip the truck to dry and grease all the bearings and I check the servos. Still no problems so far.
 
Back
Top