I've been toying with the idea of stretching my Maxx to the extended chassis and been doing some research and came up with a few parts needed, but I was wondering if anyone has done this and if there is a list of parts needed to do this?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Short To Long Chassis swap
- Thread starter Deves
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
hulkmaxx
Wanna know my secrect. I'm always ANGRY!
- Messages
- 2,159
- Reaction score
- 96
- Points
- 685
- Location
- Grantsville West Virgina
- RC Driving Style
- Bashing
Depending on what your starting with. If it's an older #4910 or #4909 model maxx, you will either have to get the #4907 transmission or come up with some custom drive shaft setup. If your wanting the extra width also you will need the 3.3 axles carriers and axles to match, and the turnbuckles for the 3.3. If you upgrade to the #4907 trans you will need the matching drive shafts also.
Mcisaacracing
RCTalk Basher
- Messages
- 40
- Reaction score
- 0
- Points
- 0
- RC Driving Style
Check out ckeithnitro thread madmaxx build he extended his chassis. Or check out my twin engine maxx build. I extended my chassis 2 3/8". Ckeith extended 2" ,I think.