Setting the mesh on a BL E-Revo?

[FastEddy]

Is there a trick to this?
Everything is covered and shielded.

 

[sweetdiesel]

You must take off the gear cover, no way around it.

 

[FastEddy]

Thank you long lost friend.
I failed to look to see that the cover was removable.
This rig is new to me.
I traded Frank my 16th BL Revo for a full size BL Revo.

Just installed RPM Arms in front and a center diff.

 

[hamz9561]

Long time no see, Eddy.

 

[FastEddy]

I'm still around kind-a sort-a
Been concentrating on the large scale stuff.
I'm trying to get back into the smaller stuff to revive the hobby part of RC again. Once its a business it all changes.

Good to see familiar faces still around.

 

[robmob]

Who are you and why are you Orange?

 

[FastEddy]

Who are you and why are you Orange?

1-Is a life long question that I'm still trying to figure out.
2-Just to P!ss you off

 

[sweetdiesel]

Be very careful tightening the screw that sets the mesh. The stock motor mount is very soft aluminum.

Check out the build I did for Erick1 for single servo conversion and BEC install.

https://www.rcnitrotalk.com/forum/showthread.php?t=74421



Are you racing at the new track up there?

 

[robmob]

Slap one of these bitches on there.

http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXYVB4&P=7