• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

Servo swap...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

h8z2luze

RCTalk VIP
Messages
5,320
Reaction score
12
Points
220
Location
Oroville, Ca
RC Driving Style
  1. Bashing
  2. Racing
I read somewhere on here that its a good idea on the x 4.6 to get a stronger servo for the steering then swap the SF-2 to the throttle/brake. Is this a good idea? If so what would you guys recommend for the steering servo?
 
lol ok i dont want to spend that much... Maybe the Hitec hs-985mg thats not to bad.
 
Last edited:
i like the hitech 645's I've had a few and there waranty rocks. but never had to use it.. i didnt think they were that slow, but thats just my opinion. plus they are about $30-$40
 
985:
SPECS: Operating Speed: 0.16 sec/60° at 4.8V
0.13 sec/60° at 6V
Output Torque: 133.31 oz-in (9.6 kg-cm) at 4.8V
Weight: 2.18oz (62g)
Size: 1.57 x 0.78 x 1.45" (40 x 20 x 37mm)

645:
Spec:
- Operating Speed: 0.24 sec/60 degree at 4.8V
- Output Torque: 107 oz/in at 4.8V
- Weight: 1.9 oz
- Size: 41 x 20 x 38mm


So the 985. Also, you're getting 4 985 servos for only $33.


EDIT: The one I sent you was the TowerPro. You can get 107 oz/in at @ 4.8V and 201 oz/in @ 6.0V. You get 4 of these for $33.
 
Last edited:
Back
Top