servo help please!

[deckerz]

ok so i had 2 servos, one was a cheap knock off and the other is a sanwa servo which is very good btw.

i took the elecs out of the sanye and stuck them in the other servo because the other servo has the right gear that sticks out of the servo i needed and now all that happens is it steers to one side when turned on. so i took the elecs out and just pluged them in and all that happens is the servo motor just spins, no center just spins one way, iv looked to make sure no wire have come loose and non have so what could it be? btw iv had problems like this before.

 

[deckerz]

nobody can help?

 

[abadk9420]

Check your trim on Ur radio, other then that i have know clue, what are these servos being used for, what channel on the receiver is the servo that is giving you problems plugged into, A little more info will help us help you. LOL!!!!!

 

[silverbird02]

I have had the same troubles before and i think it came down to a busted servo,limit switch for the travel.

 

[Scrogg]

Edit the original post some more.......it's almost coherent.
Put a little extra effort in to your typing, people will be 10X more likely to help.
You probably have a bad radio system, or you are not setting up the servo end point adjustments properly.