greenwing7
RCTalk Addict
- Messages
- 729
- Reaction score
- 0
- Points
- 0
- RC Driving Style
does anyone know which allen set i should get for HPI cars?
like metric or standard?
like metric or standard?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
screw sizes
- Thread starter greenwing7
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
I believe that all the HPI cars/trucks are metric.. The RS4 3 requires a 2.0mm & 2.5mm hex driver for the build... Hope that helps ya out..
- Messages
- 19,394
- Reaction score
- 909
- Points
- 2,075
- Location
- Central Florida
- RC Driving Style
- Bashing
- Racing
Yes, HPI cars and trucks are indeed metric.
greenwing7, check out www.mcmaster.com It's a little overwhelming, but if you look hard enough, you can find premium grade metric screws (12.9, 10.9 ect) sold in bulk quantities. I personally prefer the allen headed screws so I can use my high grade metric drivers (also a good investment). I also buy them reasonably long and cut them to size when I need them.
