craig911
RCTalk Talkaholic
guy guys,
so i just managed to snag a dynamite .31 gas/petrol engine
i'm going to see if i can fit it into my savage,
a few questions, before i get started
1 - could i keep the stock fuel tank and just change the lines since it uses a rubber o'ring seal?
if not could someone recommend a suitable tank that i could fit in its place
2 - fuel filter, I'm using a fastrax87 priming filter, could i continue to use it since its aluminum and rubber?
if not again could some one recommend a priming filter
3 - would 2.5mm internal diameter fuel pipe be ok to use http://www.ebay.co.uk/itm/TPU-Clear...079423?hash=item5d5a5e2b3f:g:XDQAAOSwu4BVkmBH
before i go about ordering parts I'm going to wait for the engine to arrive
pics will follow once the engine arrives and i can get to work with figuring out the fit
so i just managed to snag a dynamite .31 gas/petrol engine
i'm going to see if i can fit it into my savage,
a few questions, before i get started
1 - could i keep the stock fuel tank and just change the lines since it uses a rubber o'ring seal?
if not could someone recommend a suitable tank that i could fit in its place
2 - fuel filter, I'm using a fastrax87 priming filter, could i continue to use it since its aluminum and rubber?
if not again could some one recommend a priming filter
3 - would 2.5mm internal diameter fuel pipe be ok to use http://www.ebay.co.uk/itm/TPU-Clear...079423?hash=item5d5a5e2b3f:g:XDQAAOSwu4BVkmBH
before i go about ordering parts I'm going to wait for the engine to arrive
pics will follow once the engine arrives and i can get to work with figuring out the fit