Savage from Hell, what part is this plz?

[pitbull14218]

Ok, I have another thread about me blowing up my rearend. So now i have this new Savage X rear end and I'm missing this 6 sided shaft of some sort that i would imagine needs 2 screws tied into the frame of my Savage almost like how my old rearend was held in... see pics.

it slides into the 6sided hexigon like shape that would allow me to screw some bolts into the frame that would prevent the hole rear assembly from piveting


It should tie into the hole all the way to the bottom right of the Chassis.

Thanks this thing has been a nightmare, i figure i would of been able to run it today but this one little thing is holding me from having so much fun with my new setup!!!! I hope its cheap because i am broke and spent enough money on this thing to have a brand new one!

 

[ohmygahitscoby]

What you are looking for is the bulkhead joint post.

http://cgi.ebay.com/HPI-Savage-X-4x...trkparms=65:12|66:2|39:1|72:1205|293:1|294:50

You can get the at your LHS or here for $1.
http://cgi.ebay.com/HPI-SAVAGE-X-4-...trkparms=65:12|66:2|39:1|72:1205|293:1|294:50

 

[surgemaster1970]

Thats part # 86803...joint post....

You can verify here...

http://www.hpiracing.com/graphics/instr/pdf/861.pdf

 

[pitbull14218]

thanks guys, i forgot HPI has the manuals at the site.

 

[ohmygahitscoby]

While you're at it, check the differentials. Make sure they haven't stripped. If you haven't shimmed your differentials yet, I highly recommend it. Will save you money and have your differentials lasting a long time.