speedticket75
RCTalk Talkaholic
My engine is in need of a rebuild kit so i bought one......took the engine apart but caint get the sleeve to slide out.....what do i do ? tried soaking it in alcohol but didnt help......
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
savage engine problem
- Thread starter speedticket75
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Heat the block up good and hot with a blow dryer or heat gun. Should slide right out.
speedticket75
RCTalk Talkaholic
- Thread starter
- #3
i tried that on our gas stove burner but didnt work.....how come ?
if you got yahoo messenger its faster....I'm fathertyme5 on there
if you got yahoo messenger its faster....I'm fathertyme5 on there
