• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Savage 25

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
G

galinha

RCTalk Basher
Messages
47
Reaction score
0
Points
0
RC Driving Style
Hello :

My savage dont run....its like in a real car you press the cluth and press thortle at the same time..

A lot of motor noise is but ....stays in the same place.

Imagine if you dont put the gear in a car a press the thortle

Help...

Its better if you see the video...look at my feet

www.casadaigreja.com/SAVAGE25.WMV

Savage 25 Sorry Thnks a Lot for all the help....
 
spin the clutch bell my hand and see what isnt moving.. could be alot of things

1 clutch damaged
2 clutchbell damaged or not meshed
3 spur damaged
4 spur not tight enough
5 trans damage
6 drive shaft broke or out
7 diff damaged
8 wheel hexes damaged

get a bit more info

i can't really tell anything in the video



edit: your gonna burn that motor up revving it like that!!!!!!

the vid is blurry but it looks like your spur is spinning.. if it is then check your slipper pad and make sure its tight and not worn. if you have reverse it may be stuck between gears.
 
Last edited:
in the video it looks as if the spur is turning hard to tell. before your tear it all apart for transmission or clucth and clutchbell issues make sure your output shafts from the trans have the set screw in them. I have broken mine before and lost several
 
The spur is Ok
The Srews are un them

beason said:
spin the clutch bell my hand and see what isnt moving.. could be alot of things

1 clutch damaged
2 clutchbell damaged or not meshed
3 spur damaged
4 spur not tight enough
5 trans damage i HAVEOPNED...its ok
6 drive shaft broke or out
7 diff damaged -
8 wheel hexes damaged THEY ARE NEW.

get a bit more info

i can't really tell anything in the video



edit: your gonna burn that motor up revving it like that!!!!!!

the vid is blurry but it looks like your spur is spinning.. if it is then check your slipper pad and make sure its tight and not worn. if you have reverse it may be stuck between gears.
Click to expand...
I dont have reverse
 
Could be your diffs. Mine was like that but it wasn't that bad. I would rev mine like you were doing and it would barely move. Turned out to be my rear diffs that were really worn. Maybe both of our diffs are worn.
 

RC Builds

Back
Top