running wide open and its at factory settings

Welcome to RCTalk

Come join other RC enthusiasts! You'll be able to discuss, share and private message with other members of our community.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Welcome in @Pkezzy23 , I would start with removing the air filter and look down the carb and see if you have about a 1mm gap when its in the closed position. I use a paper clip to set mine close to factory. Also you might check your transmitter and make sure the throttle trim is set to zero, it may be set too high.
 
You may want to clean your carb or/and fuel line and make sure no blockage.
 

Similar threads

Back
Top