• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

RPM tru tracs

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
blckrevo33

blckrevo33

RCTalk Talkaholic
Messages
376
Reaction score
7
Points
143
Location
massachusetts
RC Driving Style
  1. Bashing
has anyone purchased and installed these on the new 5309 version? if so did it make the truck narrower? thanks
 
It doesn't matter what revo you put 'em on, they're all the same in back. I have it on my older 5309, I love it. If you run cvd's you'll need 5153 drivecups, because the true track does make it a bit wider. Just enough to make your cvd's pop apart.
 
2revo1maxx said:
It doesn't matter what revo you put 'em on, they're all the same in back. I have it on my older 5309, I love it. If you run cvd's you'll need 5153 drivecups, because the true track does make it a bit wider. Just enough to make your cvd's pop apart.
Click to expand...

thanks, the new revo is just a bit wider than the old revo so they should fit then. :D
 
Wait a minute.....Are you saying the new one is wider? I'll bet it's just the hubs or wheels then. Might wanna compare part #'s on control arms then.

Ok I did it, no worries. All the stock rear arms are the same #. True track no prob.
 
2revo1maxx said:
Wait a minute.....Are you saying the new one is wider? I'll bet it's just the hubs or wheels then. Might wanna compare part #'s on control arms then.

Ok I did it, no worries. All the stock rear arms are the same #. True track no prob.
Click to expand...

thanks, i checked also and discovred that the tru tracs are the same size as what comes stock on the new version so i ordered them last night. thanks again for the info.:D
 
only problem i had on my Revo conversion with these guys was on the 2nd arm i cross threaded the screw despite my best efforts to keep it straight. Messed with it for a while and finally just sad @#$@# and drove it home, see if it holds if not I'm just gonna go with the RPM arms and go back to my slayer carriers on the rear like up front.
 

RC Builds

Back
Top