Revo won't move

[justwannarc]

Help! My Revo 3.3 will not move when I hit the throttle. The engine revs, the clutch bell spins, the spur gear spins, and I can even see the gears inside the transmission spinning through little shift adjustment hole on top of the transmission. Yet, it still won't move. I've been battling this problem for quite a while now. It has a brand new Picco Max.26 motor, a brand new transmission, new clutch bell, new clutch shoes and flywheel, new spur gear, and the the slipper clutch tightness has been checked countless times. I have no idea what else to try so any help would be greatly appreciated because I'm two seconds from setting this thing on fire.

 

[Macguyver]

sounds like you checked everything but the diffs ...do the drive shafts move ??

 

[justwannarc]

The center drive shafts connected to the tranny aren't spinning, which made me suspect the tranny. Even when off the ground the drive shafts don't rotate. Is there a way to check the diffs to see if they are working properly?

 

[randall]

You have a pin inside of the tranny that holds the gears on the shaft the pin go'es threwthe gear and shaft and then theres a lock ring that holds thepin in place if the pin breaks everthing will spin except the drive shaft u will have to tear the tranny down but thats what it sounds like to me.

 

[mtaylortank]

that or i think if it is the same gear as the maxx . where the screw is to set the shift point there is one right next to it that holds that primary clutch assembly in place. I tightend the wrong one ones and that is exactly what my maxx was doing. the one at the angle is the one that controles the shift point, and the one that is strait is the one that holds it to the shaft. hope this helps