Revo 3.3 Won't Start

[dmichel99]

Need some help guys. Have a new Revo 3.3, ran about 1/2 gallon of fuel through it. It's always been a pain to start, taking at least a few minute of pulling it over to get it going. However, went to start it yesterday and it would not go at all, pulled for probably 1/2hr. I had run it the day earlier. Glow plug is good, lights up bright. Tried adjusting the carb to factory, still nothing. One question, how many turns out should the LSN and idle screw be? Any other thoughts?

Thanks.

 

[blckrevo33]

hsn is four turns out lsn should be flush with collar, as far as idle screw not to sure i have never really had to mess with idle screw. did u prime it? try priming it.

 

[solly69]

Try putting A FEW drops of fuel in the carb after priming it and see if it will go then

Also make sure all your needles are at factory settings

 

[bigredz71]

Check your idle adjustment

 

[dmichel99]

Figured it out

Got it figured out, thanks,
Finally realized my glow starter was not putting out enough juice.