• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Revo 3.3 Upgrades and model number

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
just waiting for the fuel to arrive then i can take it out for a bash

I'm looking at the arm replacment parts :)

---------- Post added at 1:22 PM ---------- Previous post was at 1:21 PM ----------

the only negative i can say is the remote feels VERY cheap

Is there an alternative?
 
Godddd, I hate u so much right now....in a good way.
I gotta wait til I start my 2nd job to get mine.

BTW, where did u order from and how much total with S&H, tax, etc....?
 
Hey i noticed your not too satisfied with the radio. i myself just replaced a TQ2 (not 2.4 but still cheapy feeling traxxas). i replaced with with the Flysky gt3b. i got it a few days ago, and i highly recommend it. its a Flysky GT-3B. I already own a Futaba 3PM-X and i can say hands down i prefer the $40 flysky over my $175 Futaba, for more than one or two reasons. the only place in which my Futaba would whoop Gt3b is on a rock crawler.
[ame="http://www.youtube.com/watch?v=JB6AstdA9ik"]FlySky FS-GT3B Review - YouTube[/ame]
http://www.hobbypartz.com/79p-gt3b-carradio-lcd.html
you can also get them on eBay for cheap.
i hope this helps, and congrats on the new shiny revo.
 
Last edited:
make sure before you bash to break the engine in just like your manual says.
 
I'm having trouble starting the revo

The starting engine doesn't turn over. It did but now it doesn't. Is it in some type of fail mode
 
its flooded, take the glow plug out, turn it upside down and hit the ez start. fuel will come splashing out. then glow plug back in and then give it another hit. make sure ur battery is charged. also help to warm up the block with a hair dryer or heater before trying to start it. once started dont be shy to give it full beans but dont let it rev out. u dont want it to be hitting high rpm until the 5-6th tank.

if I'm wrong feel free to correct me. iv run mine in and put a good 15L of 20% nitro through mine and its not showing signs of backing down anytime soon.

at the 2 tanks it will be slugish but just persist and go with what the manual says. once u get to the 5th tank it gets heaps better and now iv got mine run in and getting the tune really nice its a champ.
 
Got it working the starter stick needed another charge???
 

RC Builds

Back
Top