• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

revo 3.3 doesn't always shift

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

steeliebeck

RC Newbie
Messages
6
Reaction score
0
Points
0
RC Driving Style
I've noticed with my revo today that it sometimes shifts into a 2nd gear n takes off like crazy but up til this point I never noticed this..and its not all the time..why is that..is there something I can do to get it to shift all the time?
Thanks
 
The revo has a second gear to accommodate higher speeds. On the top of the tranny, there should be a rubber cap with a white sticker. Do what the sticker says with the smaller of the two 2 T allen keys. It says shift later is to the right, so turn it to the left to make the shift point earlier
 
Also make SMALL adjustments then run it, When I adjust my shift points I go 1/8th of a turn at a time until my shift point is where I want it. Warm your engine up first make a few high speed runs then start adjusting your transmission.
 
It's best to set it to shift early, it will perform better and the engine will not have to rev it's guts out to shift. If you nail the throttle from a dead stop, it should shift about 3 seconds afterr the truck starts moving. If the engine is tuned properly it will perform much better.
 
Back
Top