Revo 3.3 5309 Carburator problems

[luis.barreto.f]

Hi, I'm new to the forum. I've seen several threads on this matter, but my case is slighty different. My truck keeps on accelerating really fast no matter the changes I do in any of the needles. So I started to move the needles (I'm new at this hobby) all the way around and no luck on getting the truck starting. Then, when it started, keeps on accelerating if I go too lean and turns off by itself If I go too rich.

Your help will be much appreciated,

LB.

 

[D arrow]

Mine was doing the same thing after fine tuning by manuals &, some great inputs from the folks here. I went a little too much of adjustin the break linkage on the truck, by doing so, it does not allow the servo to go back to the center point. Back out the break adjustment knob on the truck & see if that make a diffs, I hope these helps a bit for you, you may have to re tune. I'm new to Nitro & learning stuff from good folk's here.

 

[luis.barreto.f]

Thanks man, I-ve already tuned the carburator and now is running fine. The problem was not the linkage in this case, thus it was the the HSN that was damaged when I pushed it too hard clockwise, but it's now replaced, thanks. I'm looking forward to learn from all people here too.