RC10GT Outdrives

[Rolex]

Need outdrives for the dog bones.
Anyone know who makes the best ones? Been looking for Hardened, with no success.

 

[vbgagnon]

Do you have the measurements of them? I have a bunch of old outdrives for 1/10 scale vechicles that I won't be useing. I could just send them to you.

 

[Rolex]

They're not for me, so I don't have the measurements. Hardened is the key. Apparently he's tired of replacing them all the time.

 

[Candyman]

After a little searching, I found:
http://www.niftech.com/catalog/index.cgi?mode=TC3 (they're about halfway down)

 

[.21Rc10GT]

I haven't had any problems with my stock outdrives and i have been running a hyper 8 port on them for about 3 gallons. They take some serious abuse.

 

[Rolex]

Thanks for that link, Candyman. That'll do it.

 

[rocknbil]

If you're tearing up any AE outdrives it's likely to be because the ride height is too high or low, or you're not using the spring retainers in the wheel hubs (stock) producing too much dogbone bounce.

Or you're just running a .21 engine.

If you're running dogbones, drop them and run some MIP CVD's. That will stop the breaking too.

 

[Rolex]

I made note of that, rocknbil, and I'll pass that info on to him. Thanks man.