Sold / Found Racing Revo

[jetmechG550]

Time to part ways and move on. She served me well for two years of great racing. The OS 18TM piston/sleeve has about 1 gallon on it. I broke the conrod at RC Pro Rnd 4 but replaced, since I was running a different (smaller) fuel tank than the Ofna at the time it has to be retuned, but it should run just fine. Included is the RD starter box (not pictured). Also have some extra arms (rpm rears and traxxas), extra stock axle carriers, and some other miscellaneous parts. On it the truck has:
JR 590 throttle servo
Jr 650 steering servo (not pictured)
Tekno Throttle servo mount
Tekno rx box and battery / fuel tank kit
Stock 125cc fuel tank and Ofna 250cc tank
Lunsford Ti Pushrods
Lunsford Ti Rocker Posts
Traxxas Tubez (steering and toe links)
GS Storm wing stay and mount
Motorsaver air filter
Close ratio gears installed (have the stockers too)
RD Racing Products Quick Turn Drive shaft
RPM arms on front
Traxxas extended arms on rear
RPM Axle Carriers at all four corners
1 set of used Response tires on Hurricane wheels
1 set of 40 Series Crime Fighters on Wabash wheels (23mm Prolines)
Traxxas Resonator tuned pipe
Proline single steering servo arm

all you need is a battery pack and a tx/rx. $400 shipped, paypal preferred

 

[savagefan04]

PM sent

 

[jetmechG550]

Replied, thanks for asking.

 

[Tarant]

You have PM.

 

[jetmechG550]

Replied, thanks

 

[BigSushi]

Would you be interested in parting it out? I would be interested in the entire frond and rear end - basically from the shocks forward and shocks back and the radio box. I might be interested in the steering servo too!

 

[jetmechG550]

I'd like to sell it as one whole truck, this way I'm not stuck sitting on stuff I'll never use

 

[TalonOne]

PM in there for ya. Offer.

 

[jetmechG550]

replied

 

[BigSushi]

Are the 23mm hub adapters Proline?

 

[jetmechG550]

yes, pro-line hubs. I actually only ran them one race. The track was pretty rutted up and the narrow tires were a bit of a problem.

 

[Plaidfish]

PM sent

 

[jetmechG550]

replied to all

 

[Bryson]

If you do part out just if PM with info on the mill. Just if! thanks

 

[TalonOne]

Bump for a nice ride.....somebody buy this before I spend my kids Christmas money on it.

Talon

 

[BigSushi]

Up for trades? pm sent

 

[TalonOne]

PM sent new offer pending.....

Talon Out

 

[jetmechG550]

replied deal pending

 

[jetmechG550]

Sold....lock it up