qustion about frame

[stardate93]

how much bashing dose it take to bend the frame i did and end-o front bumber to rear about 2 times i was wondering if i would have bent it and how do i check the impact was off a small bump

 

[Z400]

its deffinatly not bent

guys on here do alot of other things that include a much harde rimpact and have driven off with a frame/chassis that is un bent

 

[Mallanaga]

my revo has been to hell and back. many broken parts later... the chassis didn't budge.

if you want to make it even MORE 'bulletproof'... add the hardcore racing skid plate.

 

[nicholas655]

+1 on the revo's chassis being solid like a rock.i have bashed it to sh+t and other than the pieces sometimes breaking , the chassis always withstands to the brutal beatings i give it .
actually , my chassis did bend one time and one time only , durig winter i was going full throttle into a cement block , yeah that was expensive!!

 

[Mallanaga]

i said many broken parts later... honestly, i lied. i spent a lot of money upgrading parts, but as for breakage...

i've went through a few diffs... i forgot to put a pin in a driveshaft one time, that cost a little... popped the axle carriers a few times, then went to RPM.

you know... in hindsight, many parts have definitely not broken. wow. solid little bugger the revo is, huh? going on 3 years i've had it. we'll see how it holds up when i turn it brushless... >)

 

[pitmaster]

i jumped my revo over a truck and had a nasty crash 1 part broken lower stock a arm no bent frame. its kinda hard to bend a trucks frame. unless you run it into a crub going full out at a angle . like my dura trax . but that just snaped the frame rail lol.