Pull start conversion question

[StrechM]

Does anyone have information that they would care to share on converting a non pull start engine to a pull start engine without having to replace the crank?????

Is this possible or am I dreaming again???

 

[Candyman]

As far as I know, it's not possible without replacing the crank. Usually on a PS crank there is a little nub that sticks out from where the conrod connects which will mesh with the starter shaft to turn the crank. On a non-PS crank it's not there so there's no way for the 2 to mesh....

 

[StrechM]

Thanks Candyman, so I was dreaming, again.

 

[funwheels1]

but without dreaming, there would be no Rc nitro cars:whhooo:

 

[wingnut]

What motor are you wanting to put a ps on. At this time I can do the WS7 and the CMB raptor using the origonal crank. PM me if your still in need.