proline 23mm Adapters

[smokedsalmonkid]

help how the hell do you install these they just fall off the stock pin is too small maybe i should be using these washers that came with it but can't see what they would do please could anyone who knows give me some precise instructions i wanna get out there and run these new wabash/bowties that came today

 

[RBd Revo]

1. Place 1-2 washers on axle as shims
2. place 23mm adapter onto axle locating the axle drive pin into the recess on the adapter
3. Place wheel onto axle and lightly secure by tightening 23mm nut
4. Use the 14mm nuts (stock) to secure wheel to axle thread
5. tighten 23mm hex nut
6. Drive Revo

 

[smokedsalmonkid]

1. Place 1-2 washers on axle as shims
2. place 23mm adapter onto axle locating the axle drive pin into the recess on the adapter
3. Place wheel onto axle and lightly secure by tightening 23mm nut
4. Use the 14mm nuts (stock) to secure wheel to axle thread
5. tighten 23mm hex nut
6. Drive Revo

mate i can't thank you enough i have been baffled for the last few hours how embarassing i didn't bring the 14mm nut into play at all no wonder it just fell off pps: ill give it a try bit dark to get out there now ill have to wait till tomorrow thanks again

 

[Revo Rancher]

Make sure you sue enough washers to limit the amount of play. To much play and your Revo will wander at speed. I used 2 per axle and it was perfect.

 

[smokedsalmonkid]

Make sure you sue enough washers to limit the amount of play. To much play and your Revo will wander at speed. I used 2 per axle and it was perfect.

yeah i wondered about that I've used three seems to have done the job

is there any bigger pins available for bigger wheel adapters i dont like the idea of using the stock pins

 

[mattyk6]

I've been using the stock pins in mine for a year with no problem. Also, I used all 4 washers per axle.