"project t maxx"

[StevoRevo]

Hey there... so long story short (ened) all my bits arrived!!!
View attachment 9088

View attachment 9089

View attachment 9090

View attachment 9091

View attachment 9092

View attachment 9093

 

[StevoRevo]

more bits

View attachment 9094

View attachment 9095

View attachment 9096

View attachment 9097

View attachment 9098

View attachment 9099can't get more than six on a post.. lol

 

[StevoRevo]

and more

View attachment 9100

View attachment 9101

View attachment 9102

 

[StevoRevo]

Hopped Up!

have to dash off to work but will get back on when i get home from work and upload the photos of the maxx all put back together with all her new hop ups!!

 

[Riz23]

JEEZ-O PETE!!! You must have spent a fortune on this thing in the last few days. That is a lot of gear. Just my opinion... you will want to put the FOC tranny on if only to lighten it up with all that aluminum on it. Good luck!

 

[Metalhead Matt]

That thing is going to be a tank. Try not to hit anything too hard. Once aluminum bends, it's never the same. That's why most people run Rpm a-arms. The nylon gives just enough to save bulk heads, and they're virtually indestructible.

 

[Lessen]

Gotta love a TMaxx project. No other r/c out there has as much aftermarket product support. There are nearly unlimited possibilities. I have a TMaxx that is probably 98% aftermarket plus a couple one-off full custom pieces. It's a badass rig, too bad I've never actually run it. :shrug: