poor picco

[leesy27]

having some trouble after my picco eat its con road i am trying to strip it down but i can't get the piston liner out it the p3 .38 monster any help would be nice

Poor thing I didn't even get 1/2 a gallon throw it yet

---------- Post added at 9:04 PM ---------- Previous post was at 8:52 PM ----------

i meant .28

 

[joshman1204]

Dont know if it will work with the picco but with my 3.3 I just run a zip tie up the exhaust port and then just turn the crank to raise the piston up and it will pinch the zip tie and push the sleeve out.

 

[leesy27]

I will give it a go when I get a chance. Anybody else have any ideas that I could try if Joshman idea fails

 

[REVO-5309]

zip tie should work

 

[fdjizm]

If the zip tie doesn't work throw it in the oven at 350* for 10 min or so, the case will expand and loosen up you should be able to get it out then.

(this is how I change rear bearings but works on stuck sleeves as well)

 

[Mn Monster]

Dont know if it will work with the picco but with my 3.3 I just run a zip tie up the exhaust port and then just turn the crank to raise the piston up and it will pinch the zip tie and push the sleeve out.

same here works every time !