please help !!

[SpeedFreak15]

I got my new center cvd s and as i was putting them on the little screw shaft that goes into the cupjoint and the other little part stripped and now its stuck help me. What do i do?

 

[savagediablo]

there are several things you can do..
1) you can get a tool called Tapouts (i believe thats what its called if not somone please correct me)
2) if you got a dremel put the cutting wheel on and put a slit in the head of the screw and use a flat head screw driver and back it out
3) if you dont got a dremel... get your high powered screw gun out and get a cutting wheel attachtment and hook it up to the chuck of the drill (get 2 or 3 cutting wheels cause they will break) and do the same as the dremel trick otherwise your kinda screwed :argue: sorry to say :shrug: but hey i offered me

 

[tannera]

i used a drill when i striped a scrow i just started drilling throught the scrow and it came lose so i could get it out. takes some time before the drill go's right though the scrow.

 

[ImBroken]

You can pick up a set of "Easy Outs" from yout local Tool/Hardware store. They usually work for stripped out screws. If you have to use a drill to get the screw out, chances are you will ruin the thread in the cup joint if your not extremely careful..

 

[savagediablo]

thanks thats what i was looking for easyouts