pics of the maxx

[romeo_1984]

nothing special here just an average 3.3

ok and now a question what is the easiest way to figure out if your wheels are straight (other than looking at them) mine look straight but it pulls to the right! any help?

 

[LBSinGTX]

All the linkages same length?

 

[romeo_1984]

All the linkages same length?

yes its all stock

 

[Tmaxx96]

My Axial .28 Tmaxx

 

[insaneatvs]

maybe try to toe the right tire in just alittle it may help

 

[LBSinGTX]

Maybe check the axle carriers and pivot balls for play. Last time mine was pulling (can't remember which direction), the lower pivot ball on my rear L side was popped out.

 

[polarisman_20]

Alignment

If your truck pulls a little one way, adjust the trim just a little bit in the opposite direction on your remote. Sounds like its not a big problem, good luck.

 

[aligc]

can i ask, what is the purpose of the cable ties on the top of the engine head??

 

[chelseafc385]

can i ask, what is the purpose of the cable ties on the top of the engine head??

Its so that if you roll the car, the head wont get scratched. Instead the cable ties will take the damage.

 

[aligc]

ah i see. too late for that on mine lol scratched it the day i had it, first scratch is always the worst

 

[chelseafc385]

ah i see. too late for that on mine lol scratched it the day i had it, first scratch is always the worst

LOL, you could still do it. Just so that it doesn't get any worse. Yep, first scratch is always bad, but you get used to it after time.

 

[aligc]

oh i know lol i am used to it know. as most say trucks are for bashing anyway