• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Photo

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
B

byron

RCTalk Basher
Messages
69
Reaction score
0
Points
0
Location
oconomowoc
RC Driving Style
Piston / Photo

I chipped my piston, and I want to atach a photo to this post. How do I get a photo on here?? Never mind I think I figured it out. So here is a pic of my piston, could I still use this??
 

Attachments

  • P7310035.webp
    P7310035.webp
    24.9 KB · Views: 70
Last edited:
I actually cracked mine also. It still runs though. As long as there isn't a big gap that you will see in one of the ports when it goes up the sleeve, it'll be fine.
 
Think I would try it.
A little fine sandpaper along the break and make sure there wasn't anything in the crankcase.
 
Racer 1966 said:
Run at your own risk! But, if it were mine, I would smooth it up a little and run it.
Click to expand...

+1, might even remove alittle material from the opposite side to try and balance it better,these do turn alot of rpms'.
 

RC Builds

Back
Top