Part Question

[tmaxxfreek]

Can anyone tell me what this is, i can't find where it goes back on my savage, I'm sure its some sort of spacer or shim, i have looked all over for where it goes back and I'm frustrated

 

[NitroRC4Life]

I know I have seen a similar part on my revo. To me it looks like an a-arm shim. Usually to move the a-arms either forward or backward for more or less wheelbase length.

 

[TRXaddict]

That is for the bumper arm for the savage.. ill take a pic for you, basically these can fall off very easily and i personally zip tied them to the shock tower so if they do fall off they will hang there and ill be able to slid them back on .

Basically if you follow the bar that goes from the upper half of the bumper that connects to the shock tower that clip just holds it in.

 

[tmaxxfreek]

Thanks dude, It was Very obvious once i knew where to look........now if i only had my shocks

 

[TRXaddict]

no problem, ever since i put them on I've had no issues with them at all. And also i would actually frequently check them every drive because those rods also hold in the "arm bars" as i personally call them. they hold in the swing ams you know ? and if those bars fall out then youll probably end up breaking even more stuff or something. so just watch out but have fun !

 

[frickenjoey]

Yup it is the bumper c-clip that holds it on the back side of the shock tower. Personally I put a screw through the tower into that sucker and it cures the popping out and arm twisting.

 

[TRXaddict]

^ thats a good idea I'm going to consider doing that.