one way bearing

[cfwoodwork]

I am still having my idle isue. The guy I talked to said it sounds like I still have an air leak somewhere. Could the air leak be in my OWB. The reason I think this is because every time I take the motor apart (looking for a leak) then reassemble it. It seems to run not bad then goes into its high idle and dies. Then the second time I start it the OWB slips madly. I am so confused please help. One more Queation. I am thinking of getting a Rock Crawler, which one would be the best one to buy. (not to concerned about money Iam going to use my wifes money Ha Ha)

 

[alpinehyperlite]

Dont know what to tell you about the leak, but if you post your crawler question in the crawler section, it will get answered.

 

[Rolex]

When you take it apart, do you clean the one way bearing and the shaft with denatured alcohol?
When you reassemble it, do you seal the backplate with silicone?

 

[cfwoodwork]

I have sealed everything humanly possible and seems to run great. I had an air leak in my fuel line. I forget who told me to try the line but who ever you are thank you. Another problem I had was a throttle adjustment. I didn't even clue in that when I took my carb off I disconected my throttle linkage and changed its setting. Anyways I am pulling out the Rookie card on that one.