Ofna .28 in maxx, bare minimum requirements?

[2revo1maxx]

I sold my .26 to a friend in need, so now I have an excuse to build the maxx up again.
I know I need a mount, but is that all I need to get the .28 up and running?

 

[chickenman242]

its virtually the same motor , same size exhaust port and all that, only difference is that you can't run cheezy start with the .28.
and the .28 holds a tune sooo much better!!

 

[hotrodrob]

It's a drop in with the mount!...but really your gunna want a good clutch and Trans gears man,

 

[chickenman242]

I'm still running stock gears and the only failure I've had was an output pin , and the gears still looked like new at that point.
I good clutch is deffo a must I'm running m2c 3 shoes on both my .26 and .28

 

[2revo1maxx]

Thanks guys. I guess I should've asked if it was the same basic size as a .26, looks like all I need is the motor. I have an m2c clutch already, it's really nice!

 

[chickenman242]

I would also suggest a wheelie bar or wing because it will spend a lot of time on its back wheels lol

 

[Bill]

Wing for sure

 

[2revo1maxx]

Thanks. I think I'm going to use it in the Revo anyway.