ntc3 swaping a os .18

[Levand16]

I bought a .18 cvr os motor to put into my ntc3. I've noticed the shaft coming out of the OS motor is different than my AE motor. I've seen alot of ntc3's online with this motor but I haven't found ay info about mounting the clutch. I'm wondering what do I need to put the clutch on or should I replace the clutch with something better?

 

[Reptile]

You will probably have to cut the shaft with a dremel. It really depends on what version of it you have.

 

[Nitrobuzzard]

The OS will need to be a short shaft version or you'll need to cut it down...the crankshaft. Then get this part to mount the clutch assembly...

http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXBMD5&P=Z

good luck : )

-Nitro