nitro tuning

Welcome to RCTalk

Come join other RC enthusiasts! You'll be able to discuss, share and private message with other members of our community.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

yuckfoo

RCTalk Rookie
Messages
20
Reaction score
0
Location
beaver falls
RC Driving Style
hi my nitro motor is bogging on full throttle, i've ran nitro for awhile, not sure where to adjust,when i try to run at full throttle it bogs,any help apprecciated
 
Make sure the plug, lines, and exhaust sytem are good. An exhaust leak will cause this problem. If all checks out and you don't see any leaks then start running the high speed needle out until it revs up again.

Is it cold out?
 
it's a lil cold but unfortunately i am firing up indoors exhaust vented outside i will check for leaks thanks
 
Ok, just remember to richen the high speed needle when the ambient temperature is colder, and lean it when it's hotter.
 
o.k. just fired her up took hsp back to 3 out seemed to do o.k.temp was 205 at plug temp indoors is 75 took hsp down to 21/2 did o.k. went to 2 no good went back to 21/2 this is indoors on starter box gonna take her back outside tomorrow outside temp is in low 30's
 
Back
Top