• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Newb question.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
M

MaxxMasterS2

RCTalk Racer
Messages
91
Reaction score
0
Points
0
Location
Calgary
RC Driving Style
  1. Bashing
Searched a bit for this but still unclear.

I got my Savage 25 limited edition and I am getting it ready to break in. Do I have to remove the front bulkhead or shocks to get the casing over the radio equipment? It's a pretty tight squeeze, I was wondering if there is a trick to it, or if I have to take the front end of the truck off to fit it on there. Thanks.
 
You can lift it up and back, underneath the rollbar. To facilitate this, cut a notch on the side of the radio cover right next to the antenna. It will help it slide off.
 
It takes a little while to get it right. When I first broke in my Savage Le I did not put the radio cover cause I it was a pain in the a$$. After a few tries I got it to work. keep trying till you get it right
You do not have to remove any parts from the truck except for the body

Good luck,
 

RC Builds

Back
Top