new skids

[chuck3]

I'm looking into getting a new set of skids for my aftershock, the ones I have now were supposed to be an upgrade to stock but i soon found they werent. now I can't find any of my stockers either. anybody got a good suggestion for a set new set of skids?

 

[RC Addict]

I'm looking into getting a new set of skids for my aftershock, the ones I have now were supposed to be an upgrade to stock but i soon found they werent. now I can't find any of my stockers either. anybody got a good suggestion for a set new set of skids?

You wanting a chassis skid or the front and rear bumper/skids?

 

[syphon68]

I beleive that the LST2 and aftreshock have the same chassis and on LST2 I run the losi one in the Center and RD logics in the back and Front I think if I had it to do over again I would probably go with the Losi HD's all the way around cause it seems like the RD stuff is a bit softer than the Losi HD. my .02

 

[RC Addict]

Or these: http://www.losipartshouse.com/servlet/the-25877/DYN7211B-Chassis-Plate-Set,/Detail

 

[chuck3]

front and rear bumper skids. Those are the two that cover up the steering servo and lower
batt. mount right?

nope, not those. all of those plates are still relatively in good condition. lets put it this way for the bumper skids I have, I need to get a whole new bumper setup because the skids bent back and ruined all the plastic bits

 

[RC Addict]

front and rear bumper skids. Those are the two that cover up the steering servo and lower
batt. mount right?

nope, not those. all of those plates are still relatively in good condition. lets put it this way for the bumper skids I have, I need to get a whole new bumper setup because the skids bent back and ruined all the plastic bits

Chassis plates: http://www.losipartshouse.com/servlet/the-22210/LOSB2253-Chassis-Plates,Top-&/Detail

 

[chuck3]

sweet, now how about a new bumper setup? aluminum? or do they make them out of other things to? Its been awhile since I've looked at chassis hopups for my rig.

 

[RC Addict]

Aluminum: http://www.losipartshouse.com/servlet/the-25867/DYN7206B-Front-fdsh-Rear-Bumpers,-Aluminum,/Detail

Stockers: http://www.losipartshouse.com/servlet/the-22226/LOSB2401-F-fdsh-R-Bumpers-&/Detail

 

[chuck3]

your on top of things tonight RC! thanks!

 

[RC Addict]

your on top of things tonight RC! thanks!

You bet ya!

 

[syphon68]

after bending one set of Aluminum up like pretzels a week after getting them I don't know if the Dynamite ones will hold up. The RD logics ones haven't really bent up too much just some chunks taken out from some high speed rock clawling....