I had the truck broken in and running good. It then sat for a while (2 months) the only way to get it to fire now is by putting a small amount of fuel in the carb. I have tried priming several times and can't get fuel to come out of the line. HELP
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
new savage 4.6 owner
- Thread starter blorah
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
did you do after run procedures before it sat? you might have some gummed up fuel in your lines or carb?
- Messages
- 35,104
- Reaction score
- 1,854
- Points
- 2,198
- Location
- In my recliner
- RC Driving Style
- Bashing
- Flying
Do you mean it runs till the fuel in the carb is burned and won't run at all after that?
If that's the case, you definitely have gummed fuel in the needle valves.
If that's the case, you definitely have gummed fuel in the needle valves.
MudSlinger33
Hardcore RCTalk User
Remove the high speed needle and try shooting some carb cleaner down it.