well today is wed, tomorrow i pick up a new o.s. engine 21 tm . planing on it going in a much modded jato. i getting tired of the stock traxxas con rods splitting
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
new o.s. engine
- Thread starter moe7404
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
.21 in a Jato is bit overkill,just the way I'd like it! :thumbup:
- Thread starter
- #3
well iam thinking of adjusting the throttle so its only 3/4 open. what think?
- Thread starter
- #4
today fri got my o.s. engine. but have two other big projects to do before, i can put it the jato.allso i picked up a onfa clutch bell 19357. it has 3 clutch shoes. some things i dont know about is how the springs go on. allso it comes with al shoes, i dont like. i found that ofna has some fiber shoes, one red, one black. what is the difference?
- Thread starter
- #5
well i got it. tryed to mount a 3 shoe fly wheel and shoes. i think i useing parts from 4 or 5 different systems, didnt work. iam going to use a stock traxxas system, as bad as it is.
- Thread starter
- #6
up date: used a 3 shoe flywheel. but will try to use team associated teflon 2310 shoes, they are 2 shoe set up. had to clip some off the shoes. alas it will be a while be for running the new engine
What's wrong with your aluminum shoes? I like how they perform myself.
- Thread starter
- #8
some time back i tryed a 2 shoe al. it put al on the bell an was very hard to take off. did i do something wrong?