new engine

[parevo3.3]

so i ordered a new mill for my revo.. i ended up getting a .19 mach t.... seems like a nice looking mill.. i went to installe it today n for some reason my ez start wasn't turning over.. so I'm gonna take the mill to my lhs and see if a pull start will work better..will post pics when motor is up and running on the truck

 

[LBSinGTX]

Nice score on a new engine. Hope its fast.
Did you try to heat up the engine first? And the obvious, charged EZ battery?

 

[Teejay]

also make sure the one way bearing is the right way, will only make the engine spin if in correctly

 

[wildjokerracing]

toss the ez-start in the parts box and use a roto-start back plate, an a seperate glow ingnitor.. one ofthe best thing i ever did for my truck

 

[parevo3.3]

its a brand new mill i hope it was put together right....lol....yeah i got the ez start on there now have to wait to go and get a pull start for it........ pics to come of it on the truck

wont let me add pics says file it to larg

 

[parevo3.3]

well i got the truck out over the weekend...new engine sounds good juet need to get a good pipe for it...so i got the truck going and noticed that after it would move the truck would stall out right away...this was even if i ran it in a fig 8 it would cut out after i would take finger of trigger.... need help... the carb is still set at the factory settings....please anyone.......

 

[parevo3.3]

well ran 5 tanks thru the truck seems strong.. still not done breaking it in.....i like to baby them....will try n get a video up.... for anyone who does this engine... i reconmend getting a pull start.. the eazy start hits the carb so u have to tilt it and then u can't adjust the idle srew...so just a fyi