• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Need help!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
N

NitroXRevo

RC Newbie
Messages
8
Reaction score
0
Points
0
RC Driving Style
my truck keeps breaking headers this is the 4th one this month and they aint cheap why is my truck doing this the last two it broke i didnt flip or crash my truck
 
or you have your header flange and the pipe flange touching or bound up and the vibration is doing it i went through two before i figured it out
 
Can you post me some pics of you're exhaust area and you're broken headers please, I'll Se what I can do from there.
 
i can't post pics cause my computer is down but there breaking were it bolts to the engine rite by the weld and they dont seem to be binding could i be over tightning the screws?

---------- Post added at 12:04 AM ---------- Previous post was at 12:03 AM ----------

and thx for the help
 
same thing happend to me, try losening the wire on the pipe and put your silicon tube on then line up the bolt for the pipe then tighten your wire set screw back up. what its doing is pulling on the flange and pulling the pipe through.
thats what i did and i havent broke one since
 
is there a zip tie holding the header(the thing you're breaking) to the pipe. it might be too tight, and the heat and vibration are ending them. again, if you get pics up ill be able to really help. but no problem if you can't
 

RC Builds

Back
Top