need help

[kooljoe]

i have a picco 26 and it just stays running for like the whole tank should it do that are should it kill after so long and what should i do .thanks

 

[jon2]

I think you need to re state that cuz I get lost in the post. What is your Picco doing? I want to help you but your post.. I get lost in translation.

 

[gutterboy]

If your saying that it runs threw the whole tank and then quits when it runs out of gas, then that is a good thing, just as long as it aint runnig hot. After it goes through a tank, let it cool down before running another tank.:thumbup:

 

[FRIDGE]

first off you should read the rules as the topic of the thread is just a bit sketchy..the engine should run for a full tank is that your problem?

 

[jon2]

Ok If your picco is running nonstop that is good so long as your temps are within reason. If you are expecting the Mill to die then your perception of how the picco should run is WAY OFF!! D

Do you have a temp gun? If not you should invest in one.

Next, If you want to shut your mill down then just pinch the fuel line as close as you can to the carb nipple. It is the best method next to using your shoe against the flywheel.

Hope this helps you out.

Jon

 

[kooljoe]

ok

is what i mean is that i was told that it should run for about ten sec at idle load up then kill but mine dont do that it just stays runing at idle for the whole tank is that ok are should it load up and kill if so what do i need to ajust thanks.

 

[ZANDOR]

what are the temps. do you have a temp gun. if not buy one.we can't help you with that info.

 

[jon2]

are you meaning that you are trying to shut it off and it does this? Or it idles for 10 seconds and dies? . Are you trying to apply throttle at all? Still losing me with the grammar and spelling issue.