Need help on figuring out if my motor is broken or it isn’t connected to the escm

[Peyton Longstreth]

I just bought a used Xxx-Scb Brushless Rtr,Avc:1/10 2Wd Sc Buggy and the motor does not run when I press the throttle, the steering works perfectly. The controller is a dx2e dsmr radio system, the escm is a 45-amp Tazer bl esc. Any feedback will help.

 

[shizo]

I just bought a used Xxx-Scb Brushless Rtr,Avc:1/10 2Wd Sc Buggy and the motor does not run when I press the throttle, the steering works perfectly. The controller is a dx2e dsmr radio system, the escm is a 45-amp Tazer bl esc. Any feedback will help.

My ideas since I just had super issues with my Spektrum receiver and radio, double check Throttle port and try all weird stuff for calibration. Yes, I am a newb, but it took me like 2h to figure out till it finally worked. Steering worked 80% of the attempts, but Throttle would not do anything or sometimes only while steering left or right.

Edit:
Actually, I did not figure it out, it just worked at a point as it should...

 

[biggman100]

I just bought a used Xxx-Scb Brushless Rtr,Avc:1/10 2Wd Sc Buggy and the motor does not run when I press the throttle, the steering works perfectly. The controller is a dx2e dsmr radio system, the escm is a 45-amp Tazer bl esc. Any feedback will help.

Since you bought it used, a couple of thoughts. Did it come with the battery? Nimh or Lipo? Is the battery fully charged? What charger are you using? If it came with a used battery, the battery may be wore out and wont take a full charge anymore.