• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Lrp z.28 s3 break in

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
yeroc1982

yeroc1982

RCTalk Talkaholic
Messages
467
Reaction score
3
Points
108
Location
canada
RC Driving Style
  1. Bashing
  2. Racing
I'm goin to break in my new motor. How many tanks u think break in should be? Thing is, I have a full gallon of 30%. Should I just buy a couple quarts of 20-25% and then go to 30% or should I use more to break it in? And what is the best break in procedure for this mill?
 
Use heat cycle. It should take 1 full gallon to be fully broken in so take it easy.

And pre-heat it to 200F so it will start easy.
 
I just picked up my lrp z.28 s3. Goin to break it in once it stops raining. Anyone know if the factory needle settings are good for break in? Inthe book it says if the settings are no good, turn in all the way then 3.75 turns out and start there so does than mean it's set from stock? I don't hav My heat gauge right now so I gota take it easy u know?
 

RC Builds

Back
Top