just some insight on my revo

[nmrcc racer]

i got my 3.3 when they first came out since then the only thing i have had to change is the ball ends since my wheels would point out when since i took it out of the box. since then i have gone thru 3 glow plugs 5 gal. of 33% traxxas fuel put on proline bowties on dish wheels, motor saver epoxied to old filter housing, changed glow plug wire can't remember what brand, i run silver springs in front with 30k, purple in rear with 60k, and p2 rockers this is all i have done for now

things i want to gete for it this next season
integy alloy hex wheel hubs 17mm
traxxas response pro soft tires
center diff
rear brake kit
resonator pipe
sway bar kit
wing kit
150cc tank
platinum edition body
aluminum tube turnbuckles and pushrods
lunsford hinge pin set
digital high torque servo for single servo steering
slayer electronics boxs
close gear ratio
rpm arms

is this good , did i miss anything ?
and if you wanna c our track this is what it looks like
http://www.myspace.com/nmrcc

 

[OLROY2009]

Have you fig out a $$$
for all that vs buying
a platinum?

 

[nmrcc racer]

i am not going to get it all at the same time am getting it slowly over time some from friends at the track others here and there
some parts i will be trading for some of my other rc stuff i have to many rigs that i don't like my tc3's

 

[jnjritz]

If you don't like them. I'LL TAKE ONE. J/K
Anyway over time i don't think it will be bad. But if you were to do it all right now i would just buy a plat.

 

[nmrcc racer]

ya i know i got this back in 2007 should have waited i guess and would have saved a bundle
and its not the cars i don't like its the ppl at the only indoor track around 1 of my tc3's is the factory team kit and i have enough spare parts to make the other the same