• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

It has arrived :)

  • Thread starter Thread starter hitman1985
  • Start date Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
H

hitman1985

Guest
ye ha, my savage including Remote is finally arrived today :)

IMG_0898.gif


IMG_0897.gif


IMG_0896.gif


ok now i would like to see some suggestions for:
Servos to use since these spektrum things are goin in the trash,
battery packs / wire options / plugs to use
battery packs and a charger
some mods maybe for the safety of the trucks electrics :)
filter oil or complete filter kit suggestions are very welcome too


thank you guys a lot
 
Last edited by a moderator:
Servos i thought about were 5985mg steering and 5965mg th/br
 
Last edited by a moderator:
Let me know how the spektrum radio works out. See how much range u get cuz I only get like 350feet.
 
as if that wasn't enough :)

i never ride more then 150 ft away usually :)
 
Ya just keep the servos, they are still decent. 350 feet is ok I guess but I hear other ppl getting 800 so....
 
it was just meant for symbolic, i ll kick them in the bucket / parts bin :)
 
alright i took her for a test spin or whatever got out of it in the morning, what happend is as follows:

started it up, let it warm up a bit, as i hit 230 F the truck just revs up and wont let me slow it down :(

anyone got some help ?
 
Too lean maybe. I dunno, its hard to tell with the info u give.
 
what info is needed ? i'm new as u prolly see :)

with reving up and non responsive i mean it just idles and gets higher and higher and higher until it finally just revs up to a like 15mph roll and so on :)
 
what idle settings (my remote / servos didnt move as far as i was able to tell)

any1 know that standard settings for the HSN LSN ? thanks :)
 
got it preowned so i dont have manual or such, but i just found it online, so all screws are flush = factory setting, i dont know what else could cause it to act like this
 
Last edited by a moderator:
tank filling doesn't matter, it happend with full as well as with half ;) but the thing is, if its cold it runs fine in idle, once it gets warm it just revs higher and higher and higher, idk how other to describe, if we can't figure it by friday ill upload a video :)
 
Does the idle speed change when braking? Have you pulled the airfilter and verified the carb position at idle? Does adjusting the screw move the throttle valve? It sounds like the idle screw is holding the throttle open just a tad too much or you're a bit lean on the lsn.
 
well right now i just went ahead and packed up my remote to send it in for repair to horizon ;) since the cable on the receiver was broken, so before anything ill confirm that the radio is perfect, also i ve just decided to remove both servos and i ll put them out for sale sometime soon, i m goin to buy some hitec ones, or whatever i get suggested.
thanks so far, the needles will be checkd as soon as i get the servos back onto it and the remote in.
till then ill halt all work :(
 

RC Builds

Back
Top