• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Isnt Pumping Gas

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
M

MAD-MAXX

RCTalk Addict
Messages
856
Reaction score
0
Points
0
RC Driving Style
Well My Servo And Fail Safe Problems Are No Longer Problems :) Thanks PPL. But Now It Wont Pump Gas. I Have The No Primer Gas Tank And I Was Holding The Exaust Hole Shut And It Barley Pumped n e. Whats amater w/ it? my gasket has a little cut in it. and the plastic thing that goes inside is broken. could that be my problem? My roto start battery wasn't very charged so that may be the problem. I'm charging it right now and when its done i will try again.

thanks
mark

okay its pumping gas now. i was just trying to start it and it was starting for a little bit. my roto start back plate is just spinning now. it wont turn over the engine or n e thing. wtf!?!?!

I JUST PUT IT BACK TOGETHER!!! THAT SAVAGE HAS BEEN NOTHING BUT JUNK! I'm GETTING SICK OF THIS!!! SO PLZ HELP ME PPL!!!

Mark
 
Oneway probably got burned up from constantly trying to start it. Pull it off and try cleaning it with some DA. If it still just spins, then a new oneway is in your future.
 
You may have to replace the actual shaft as well as the one-way. If you are spinning the Rotostart for more than 3 seconds it is not going to work.
 
Thats My Problem Then. Well Thanks Guys I Was Kinda woried It Was Something With MY New Wasp. :)

Mark
 

RC Builds

Back
Top