nitronewbie
RC Newbie
I just got my INTEGY drive shafts today(ya,ya,ya I know!!).But i was wondering if i had to split the front and rear gear case's to install them? Sorry for the dumb question.....But i just don't know...:redface:
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
INTEGY drive shafts
- Thread starter nitronewbie
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
nitronewbie
RC Newbie
- Thread starter
- #2
Tmaxx96
Gone - bye bye.
Those are CVD's
No You shouldn't have to split them take the diffs out then take the drive shafts out then take the output yokes off the diff DO NOT SPLIT IT OPEN theres an allen screw going through the Yokes take it out pull it off and then slide the new metal yokes on then just throw the new CVD's in. OH..... Dont forget to Tighten the Yokes or they will fall off
Glad i could help nathan :banned:
nitronewbie
RC Newbie
- Thread starter
- #4
Thanks Nathan!
Tmaxx96
Gone - bye bye.
no problem