• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

I am supposed to be using blue locktite on screws

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
pontiac69

pontiac69

RCTalk Member
Messages
32
Reaction score
0
Points
0
RC Driving Style
  1. Bashing
I installed allum bulkheads and the screws keep backing out after a few tanks of fuel. Am i supposed to have put blue locktite on anything going into the allum? They are the only screws backing out.
 
I had the same problem with my emaxx because I forgot to use locktight.. if you dont want to loose tomany screws I would use it...
 
Yes, I would highly recommend you use locktite. Make sure you allow it to dry up some before you put em' back in though.
 
yeah thats a good idea because when it is fresh and wet it runs everywhere on you so thats a good idea!!!
 
Thanks. We are done with this thread. I put some blue loctite on last night and ran the car today. Everything held perfectly.

Thanks
 

RC Builds

Back
Top