Hpi rush compatibility

[CountryNitro]

So my old Tmaxx ate its clutch bell today. I'm deciding to put it up for a bit and work to bring my old Nitro Rush back to life. My main question is, will the T15 from the Rush EVO bolt into the old rush? And if not, what engine(s) will? Because the old Nitro star in it is wasted as far as compression goes.

 

[Aed3810]

What engine was in it before? In my experience so far (which is only a year and a half) most engines of the same displacement have the same fittings for the engine mounts. You might just want to check the shaft to make sure that the clutch will mesh properly. I could well be wrong though.

 

[NitroHawk]

The T15 should drop right in as a replacement for the nitro star .15fe, did that same swap on a nitro rs4 mt.

 

[CountryNitro]

What engine was in it before? In my experience so far (which is only a year and a half) most engines of the same displacement have the same fittings for the engine mounts. You might just want to check the shaft to make sure that the clutch will mesh properly. I could well be wrong though.

It currently has a worn .15fe in it. I figured they were the same but wanted to be certain before I ordered one.

 

[Aed3810]

Should fit perfectly onto your existing mounts in that case.