HPI-Killer's 2.5r Traxxas TMAXX Build Thread

Welcome to RCTalk

Come join other RC enthusiasts! You'll be able to discuss, share and private message with other members of our community.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Status
Not open for further replies.
You can file out the chassis just enough to shimmy the mount rearward

Good thought but the mount has to go forward, the cb I'm using has a rounded stub coming out from the gear on the cb, held on with a hex screw instead of the standard e clip . I sanded the screw head down for maximum reach but wasn't enough. I am going to take a 1/16" off of the trans case and try again, if that doesn't work I will have to buy a slimmer cb for it.

-----
I also tried a 15t cb but fuel tank gets in the way so I can't even mesh it...
 
Those screw on always cause an issue on the maxx rig, ya you can take a 1/16 off the trans no problem
 
Here is a Twin Tmaxx I put together.
3” longer, 2” wider 2X the power.
Just installed lager stinger pipes for better performance.
44073371-B830-4C17-881A-96D93A894CEC.png
3EF8976B-A6F1-4FD0-B4D6-1348E7B60583.png
 
Status
Not open for further replies.
Back
Top