how do u prime a primeless tank??

[pissant]

since there is no prime button, what do i do?

 

[robmob]

Put your finger over the exhaust stinger for a couple of seconds untill you see fuel get to the carb.

Rob

 

[El Pirata]

Originally posted by robmob
Put your finger over the exhaust stinger for a couple of seconds untill you see fuel get to the carb.

Rob

Pull the starter a few times while you are waiting...

 

[robmob]

I was assuming he would know to pull the starter or press the rotostart button while covering the stinger.

Rob

 

[El Pirata]

Okey dokey. Glad you're still on your toes.

 

[NCNitro]

Originally posted by El Pirata
Pull the starter a few times while you are waiting...

LMFAO

 

[El Pirata]

I aim to please.

 

[WHEELIN24/7]

Originally posted by El Pirata
Pull the starter a few times while you are waiting...

Bro....That was awsome!!!!!:bow:

 

[ImBroken]

That was funny... I'm still laughing over here.....lol

 

[captain crash]

i didn't know that . so it's better to crank and plug at the same time?

 

[El Pirata]

Are you serious?

 

[Çh®i§tiªñ]

Yes - for the first few pulls. This will allow the fuel to get to the carb quicker. Once you see the fuel enter the carb, you should be able to stop right there and begin with the glo-ignitor process.

 

[spanko123]

sumtimes if that dont work you could also put just a little bit of fuel directly into the carb but no too much you dont want to flood it

 

[jon2]

Be careful for Non pullstarts as the starter box winds your engine up fast enough to pull the fuel to the carb. If you do have a pull start and this still doesn't happen I would check your fuel lines. I always zip tie the end to give it a secure connection. .

Oh yeah .. EL..damn that was friggin hilarious!!