• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Hot Bodies Adj Alum Heat Sink Engine Mount

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
S

Skela

RCTalk Racer
Messages
113
Reaction score
0
Points
76
RC Driving Style
HB Adj Alum Engine Mount HELP

Hi a quick question,
Have some of you that run with the Picco.26 tried it together with the Hot bodies alu heat sink engine mount and got it to fit in the savage without doing any mod. ??????

I have just got the HB mount and I tried to install it but my clutch bell “house” now hits the spur gear. I have looked at the HB mount and it seems that the engine sits a little further ahead on theHB mount then on the stock engine mount

savageenginemount.jpg
 
Last edited:
I believe that some on this site have tried it. I have read where you need to tweak the bottom plate to take the center drive shaft. I'll see if I can dig up the thread on that topic.
 
Hi sky I think we talk past each other, it sound like it’s the thread about the HB engine plate and some heavy duty dog bone you referee to, so I just edited my thread a bit and added a picture, it’s the HB engine mount I'm having trouble with
 
Last edited:
You are correct. My mistake. I thought the engine plate and mounts were an integrated piece. I stand corrected.

I believe WoodiE and a couple of other members have that particular set up. I think WoodiE's is on a Hyper 21 8 port. But I am sure that someone has it for the Outlaw. I'll keep looking.
 
Am I the only one that has brought a picco and the HB engine mount that can’t get it to fit in the savage?? Come on some of you must have tried it or something!
 

RC Builds

Back
Top